Inscribers¶

Here you’ll find some example setups for automating Inscribers.

Easy Setup using AE2¶

This setup is incredibly easy, because it takes almost no effort to set up and is technically infinitely expandable. A drawback is that it takes quite a lot of Channels if you want to scale it up.

Items required¶

Items required

Patterns¶

For the Circuit Patterns

Remove the Inscriber Press if you copy the recipe from EMI!

For the Processor Patterns copy straight from EMI. You don’t have to edit anything

Inscribers¶

For the Inscriber making the Circuits add a Universal Press.

For the Inscriber making the Processors.

Using Extended Inscribers

If you’d rather use Extended Inscribers, make sure they are locked to “Stack to 1”
Make the Pattern so that Batches of 4 get made each time. Middle-Click to change the amount

Place two inscribers, one with Universal Press and one without

Always make sure that you have auto-export through any extraction side enabled

Pattern Provider¶

For the Pattern Provider with the Press

For the Pattern Provider without

Expansion¶

You want to expand the setup?

You can add up to 4 Inscribers around a single Pattern Provider
Repeat all the steps above and make a second setup. AE2 will use both for autocrafting

Snow’s SFM Setup¶

This Setup was made by 𝓢𝓷𝓸𝔀 on the ATM Discord.

Items required¶

This list assumes you’re going for the scale shown here.

Items required

SFM Code¶

Super Inscriber Factory

name "Super Inscriber Factory"

every 2 ticks do
    input fe:: from cube top side
    output fe:: to power top side
end

-- setup, can be disabled after presses are loaded
every 200 ticks do
    input from buffer
    output 4 item::*_press to each insc1 top side slots 0, 4, 8, 12
end

-- reset - fixes when inscribers only get 1 - 2 ingredients
every 200 ticks do
    input from insc2 slots 0, 1, 2, 4, 5, 6, 8, 9, 10, 12, 13, 14
    output to buffer
end

-- each
every 20 ticks do
    input from buffer
    input
        printed_silicon,
        printed*processor
        from insc1
        slots 3, 7, 11, 15
    output
        diamond,
        gold_ingot,
        certus_quartz_crystal to each insc1
        slots 2, 6
    output silicon to each insc1
        slots 10, 14
    output to buffer
    forget


    if buffer has >= 4 "redstone"
        and buffer has >= 4 printed_silicon
        and buffer has >= 4 printed*processor then

        input from buffer
        output 4 printed_silicon to each insc2
            slots 1, 5, 9, 13
        output 4 printed*processor to each insc2
            slots 0, 4, 8, 12
        output 4 redstone to each insc2
            slots 2, 6, 10, 14
        forget
    end

    input from insc2 slots 3, 7, 11, 15
    output to pp
end

Setup¶

Make sure the Processor Patterns follow this template.

Important info

Make sure the Mekanism Energy Cube allows output to the Top.
insc1 should be 2/3 of your Inscribers, while insc2 should be the other 1/3.

Bugged Interface

As of the 26th August the GUI for the Label Gun is bugged, use Shift + Scroll instead

Workaround

A workaround for if you have GUI’s that are invisible or not showing properly, go to your accessibility settings and change this setting to off

Applied Energistics 2 | CurseForge